Toshiba MA-141 - Manual (Page 30)

READ(X) AND RESET(Z) REPORT
The following table shows the key operation to take each report and its
content. The "X" and "Z" reports have exactly the same content printed,
except that:
1, The "X" reports allow to read the totals but not clear memories, while
the "Z" reports allow to read the totals and at the same time all
the resettable memories will be cleared when the reports have been
issued,
2, The symbol "X" is printed on the top line of a "X" report, while "Z"
is printed on a "Z" report, to indicate the type of report.
3, A reset count is printed on the bottom of a "Z" report only.
TABLE OF X AND Z REPORTS
(REPORT .NAME)
AUTO SCAN READ
AUTO SCAN RESET
(KEY OPERATION)
Mode Lock: X —i
Mode Lock: Z
(CONTENT & REMARKS)
All DEPT & Transaction
I 1AT/TL1 Totals that have memories
* 7. opened.
PLU AUTO SCAN READ
PLU AUTO SCAN RESET
Mode Lock: X
Mode Lock: Z —
All the totals of PLUs
I PLU^I that have been set. (The
Z report will not clear
the preset prices.)
INDIV. DEPT. READ
INDIV. PLU READ
PLU ZONE READ
Mode Lock: X
ex.) I DEPT Ti ^ |DEPT2~1
IDEPT 3l->|PEPf^
-»rwi
----- U t T tl I
Mode Lock: X
ex)IPLU CODE 1 1PLU1
t J
may repeat
[sU
may
repat
... IAT/TLI
Mode Lock: X
I START PLU CODE]
X I
—»[END PLU CODE
-i.[PLUl
Designated Department Item
Count, and Total (Customer
Count—optional)
([ST I...to obtain the sub­
total of the departments
printed between two |ST]
key depressions.
IAT/TLI...to obtain the
total of all the depart­
ments printed so far and
to finalize the report.)
Designated PLU Total
([Sf] and F a T/TL] funtion
the same way as in the
INDIV.DEPT.READ operation
above.)
Totals of the PLUs desig­
nated by the zone (from the
START PLU through the END
PLU)