Toshiba MA-141 User Manual
Page 51
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PROGRAMMING TAX TABLE (Condition: after a Z reset and GTZ reset)
Mode Lock: SET
1) TAX 1 FULL BREAKS
Key Operation: |max. amount non-taxable] ITXl/M-l
I max, amount for tax levied!|TXl/M|
[ max. amount for 2^ tax levied I ~-»[T
xi
7
m
1
Repeat until the "A" Break is entered.
I
max, amount for Ngf tax levied [ —»| TXl/^ . . . "A" Break
I
ST
I
(to indicate the "A" Break entry)
I
max, amount for N+ljii tax levied ¡—» I TXl/wl
[max, amount for N+2j^ tax levied 1—>[TX1/^
Repeat until the "B" Break is entered.
1AT/TL 1 (to end)
NOTE: The amount etnry may be maximum 4-digit value (up to 9999?i).
2) TAX 1 "A" BREAK AND
%
RATE COMBINATION
Key Operation: First set the "A" Break following the same operation
up to the "A" Break entry and the j ST[ key depression
in "1) TAX 1 FULL BREAKS" above.
i
[
tax
rate
applied when exceeding the "A" Break amount
(max, 4 digits, up to 99.99%. Do not use the [T]
key. The fraction of the amount resulted from this
%
rate calculation will be rounded off.)
IAT/TLI (to end)
3) TAX 1
%
RATE ONLY
Key Operation: joj
iTXi/Ml—»I~sf1-^|TAX
rate
I—»I^'/
tl
I
(The conditions
of the rate are
the same as the
above TAX RATE.)
NOTES: 1. If only one tax modifier key ( |TX/MI ) is installed on the key
board, use the | TX/M | in place of the 1 TXl/M I in the descrip
tion 1), 2), or 3) above.