Replenishing the store name stamp with ink – Toshiba TEC MA-1040-400 Series User Manual
Page 57
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

When the receipt and journal print is
too light, replace the ink roll in the
following manner:
1. Remove the Ribbon Cover (Fig. 1).
2. Remove the old ribbon cartridge by
pulling it toward you (Fig. 2).
3. Install a new ribbon cartridge in the
reverse order to Step 2 above (Fig,
3).
4. The ribbon cartridge is a comsumable
product. Be certain to use genuine
ribbon cartridge supplied by your TEC
representative
REPLACING THE RIBBON CARTRIDGE
REPLENISHING THE STORE NAME STAMP WITH
INK
When the store name stamp is printed too
lightly,
replenish
the
ink
in
the
following manner:
1. Turn the Power Switch to OFF, Remove
the Paper Cover.
2. Withdraw the store name stamp with
the protruding part pinched with your
fingers (Fig. 4).
3. Apply ink on the pad on the rear side
of the Store Name Stamp. The amount
of the refilling should be addjusted
according to the density of the
printed message, but the limit of 2
cc should not be exceeded, (The ink
bottle supplied contains 5 cc of ink)
(Fig. 5)
4. Follow the reverse order of Step 2,
and then attach the cover.
Ink
Fig. 4
Fig. 5
- 53 -