RCA P46729 - Manual (Page 40)

Design Specifications
General
Power requirement: 6VDC
Power consumption: 5.2 W
'
Weight: 1.7 lbs. (780g)
Dimensions: 4-3/5"(W) x 4-3/5"(H) x 10-1/5"(L)
(117 X 120 X 259mm)
This digital apparatus does not exceed the class B
limits for radio noise emissions from digital
apparatus set out in the Radio Interference
Regulations of the Canadian Department of
Communications.
Video Recorder Section
Format: 8mm
Record/Playback System:
Two video record/playback heads
One flying erase head
Headwheel Cylinder Diameter: 40 mm
Video Signal: El A Standard NTSC Color
LTnterférence radioélectrique générée par cet
appareil digital ne dépasse pas les limites de la ;
classe B édictées par le Réglement sur les
pcturbations radioélectriques du Ministrére
Canadien des Communications. .........................
Camera Section
Scanning: 525 Lines/60 Fields/30 Frames
Image Sensor: 1/3" high-resolution,
solid-state CCD Imager
Tripod Mount: One 1/4" threaded hole
Lens: fl.8
8:1 (6-48mm)
Diameter: 37 mm
Earphone Jack: Monaural 8 ohm minijack
All features and specifications are
subject to change without notice.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by
Thomson Consumer Electronics, Inc. may void the
user’s authority to operate this camcorder.
38