RCA P46729 - Manual (Page 30)

Time Counter with Memory Stop
The time counter display shows the actual time elapsed when recording or playing back a tape. The time
counter quickly locates the end of recorded segments. Note the reading when you are finished recording or
playing back a tape. Before you start to record or playback a tape, press the COUNTER /?£5£T button to set
the counter to “0:00:00".
For example, you recorded a 10-minute segment. Later, you want to locate the end of your recording. Insert
the cassette and fast-forward the tape until the time counter reads “0:10:00".
COUNTER
MEMORY
Button
COUNTER
RESET
Button
Memory-Stop Feature
The memory-stop feature helps you locate a certain
point on the tape. When memory stop is turned on,
the tape will stop automatically during rewind or fast
forward when the time counter reaches “M 0:00:00".
1. Press the COUNTER MEM (memory) button to
turn on the memory-stop feature. An “M"
appears in front of the time counter.
Time Counter
with Memory-
Stop Feature
Turned on
Seconds
Minutes
Hours
Display in Viewfinder
2. Locate the place on the tape you want to return to
and press the COUNTER RESET bniion to set the
time counter to “M 0:00:00".
3. Continue to record or play the tape. When you
want to return to the place you marked, press the
thumb trigger to stop recording or the STOP
button to stop playing back the tape.
4.Make sure the POWER switch is in the PLAY
position, and then press the REW (rewind) button.
The tape will rewind to the time counter reading
of “M 0:00:00".
Notes: The corresponding buttons on the remote control
can be used to operate the camcorder.
If you rewind the tape farther back than a counter reading
of “0:00:00", a minus will appear in front of the counter.
28