Listening to tapes, Playing a single tape – Kenwood SPECTRUM 850 AV User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Listening to tapes
Playing a single tape
Before'starting, be,sure that th^ TIMER svy,itch is OFT'
1 Insert a tape into a cassette yveiLThe tape type
(Normal or Chrome) is automaticajly selected. .,,
2
Set the play mode.
'
.
T
_ . .
ciD plays both sides of the iape nepeatedjy.
^ ) ^ops after playing both sides of the tape.
___ stops after playing [ side of the tape.
3
Set the Dolby Noise Reduction mode by moving the.
switch to. the proper setting for the tape you’re., :.
playing. For e>^mple, if your playing a tape recorded
using Dolby C, select Dolby C
4
If you’re using the. remote, press the AUDlQ'button ..
on the remote.UPtifthe remote’s.display shows. TAP
A or TAP B (depending on which you're.listening to).
5
On either the remote or the cassette deck’s front.. .
panel, press the
4
or ► button (depending on which,
side of the tape you want to listen To) to begin play.
6
Press the ■ button on .either the remote or the
cassette decks front pane! to stop play.
About the direction indicators:
The. ◄ and ► indicators.sho,w the direction the tape is '
moving. If you turn the power OFF. the tape plays in the
same direction when you turn the.power back ON,. ..
37.