Kenwood TS-130SE - Manual (Page 6)

2.2 ACCESSORIES
The following accessories are furnished with the TS-
130SE.
DC power cord (E30-1638-05)........................................ 1
Fuse, 20A (F05-2034-05)................................................ 1
Instruction manual (B50-3954-00).................................. 1
2.3 INSTALLATION
It is preferable to choose an operating location that is dry
and cool, and to avoid operating the transceiver in direct
sunlight.
Allow adequate ventilation, particularly during mobile opera­
tion.
NOTE:
The TS-130SE is supplied to receive on the following
frequencies (transmission is disabled):
10 MHz band (10.0-10.25 MHz)
18 MHz band (18.0-18.5 MHz)
24.5 MHz band (24.5-25 0 MHz)
SECTIONS. CONTROLS
@ ANTI vox CONTROL
(g) DELAY CONTROL
@ VOX GAIN CONTROL
(Q) SUBDIAL
0 METER
DIGITAL DISPLAY
0 STANDBY SWITCH
0MODE SWITCH
0 MIC CONNECTOR
0 PHONES JACK
0 PROC SWITCH
0 VOX SWITCH
0 METER SWITCH
(g) FIX SWITCH
(||)MAIN TUNING CONTROL
Fig. 3-1
3.1 FRONT PANEL
0 METER
The meter has three functions, two being selected by the
METER switch. In receive the meter is automatically an S-
meter showing receive signal strength on a scale of 1 ~ 9, 9
-I- 20, -h 40 and + 60 dB. In transmit, the meter shows
Ic or ALC level, depending on METER switch position.
0 DIGITAL DISPLAY
The digital display indicates true operating frequency to an
accuracy of 100 Hz.
0 MODE SWITCH
SSB............... Permits SSB operation. LSB is normally
selected for opration on the 3.5 and 7 MHz
bands, and USB for operation on and above
the 10 MHZ bands.
Switching between LSB and USB is done
automatically by the BAND switch.
g)FIX INDICATOR
§)VOX INDICATOR
(0)RIT INDICATOR
(0) CARRIER LEVEL CONTROL
(T t ) MIC CONTROL
RF GAIN CONTROL
AF GAIN CONTROL
(Q) IF SHIFT CONTROL
BAND SWITCH
@ RIT CONTROL
0 POWER SWITCH
NOISE BLANKER SWITCH
RF ATT(RF ATTENUATOR) SWITCH
0 NAR WIDE SWITCH
_ RIT SWITCH
Front Panel
REV............... During SSB operation, this position selects
the reverse side band; from USB to LSB or
vice versa.
CW................. Used for CW operation.
0 STANDBY SWITCH
This switch selects receive or transmit function.
In the REC position, the transceiver is normally in the receive
mode unless the microphone PTT switch is depressed. In
the SEND position, the TS-130SE is switched to the
transmit mode.
CAUTION: Do not transmit without an antenna or dummy
load. Equipment damage will occur. Such damage is not
covered by warranty.
0 MIC CONNECTOR
Connect your microphone (MC-30S, MC-35S, MC-50, MC-
60/N4, etc.), referring to Fig. 2-1. The TS-130SE accepts
both low and high impedance microphones.
6