Kenwood TS-130SE - Manual (Page 14)

4.7.3. KEY CONNECTION (Fig. 4-9)
Your key should be connected as illustrated in Fig. 4-9.
When using an electronic keyer, make sure that polarity is
set for positive. Always use shielded line from the key to
transceiver.
4.8 MOBILE OPERATION (Fig. 4-10)
The TS-130SE being compact in design, is ideal for mobile
operation. Satisfactory mobile operation is achieved
through proper power and antenna connection, and thought­
ful transceiver installation and adjustment.
4.8.1 TS-130SE INSTALLATION
Secure the TS-130SE under the dashboard using an op­
tional MB-100 mounting bracket as shown in Fig. 4-10. As
an alternative, use strapping, making sure that the TS-
130SE will not slip out of place while driving the vehicle.
NOTES:----------- —----------------------------------------------------------
1. Do not install the TS-130SE near the heater outlet.
2. Allow sufficient space behind the TS-130SE to ensure
4.8.2. HOW TO HANDLE THE POWER CABLE
When connecting or disconnecting the power cable to or
from the power connector, be sure that the power switch is
always in the "OFF" position. Observe polarity of the cable.
The TS-130SE operates on 13.8 VDC, negative ground.
Battery polarity must be correct. The power cord is color
coded:
CAUTION: Observe battery polarity.
14