Clarion ProAudio VRX 935VD VRX935VD - Manual (Page 18)

22
VRX935VD
English
Owner
’s
manual
Opening and turning the display
20˚
20˚
Basic Operations
WARNING
• To prevent the battery from going dead,
operate this unit with the engine
running, if possible.
• When the liquid crystal panel is operating,
be careful not to get your hand or finger
caught between the panel and main unit
or the instrument panel of the car.
Standing up the liquid crystal panel
1. Press the [OPEN] button and the liquid
crystal panel comes out and stand up
automatically.
∗ While the liquid crystal panel is opening or
closing, the LED of the [FUNC] button blinks.
Note:
• If the liquid crystal panel stops in the middle of its
operation, press the [OPEN] button to house the
panel and press the button again to stand it up.
The unit enters the same display mode as the
display was turned off the last time.
Adjusting the angel, etc. of the
liquid crystal panel
The angle of the liquid crystal panel or
protruding amount of the panel from the
mounting surface can be adjusted depending on
the mounting angle of the unit or light coming
into the car.
● To adjust the angle
1. Every time the [TILT] button is pressed, the
liquid crystal panel tilts forward or backward
at up to about 20 degrees. The adjusted
angel is stored in memory.
Note:
• Do not move the liquid crystal panel by hand.
● To adjust the slide position
1. Press and hold the [TILT] button and release
when a beep is heard.
The liquid crystal panel slides forward or
backward. The adjusted slide position is
stored in memory.
* There are 3 adjustable positions available on
this panel.
Housing the liquid crystal panel
1. Press the [OPEN] button and the liquid
crystal panel is housed automatically.
Note:
• When leaving this unit unused for a long period of
time or leaving your car, be sure to house the
liquid crystal panel into the main unit.