Kenwood TK 3100 User Manual
Protalk™ vhf, Protalk™ uhf
This manual is related to the following products:
Table of contents
Document Outline
- INTRODUCTION
- FCC LICENSE INFORMATION
- MODELS COVERED BY THIS MANUAL
- NOTICES TO THE USER
- CONTENTS
- UNPACKING AND CHECKING EQUIPMENT
- PREPARATION
- GEniNG ACQUAINTED
- OPERATING BASICS
- CHANNEL FREQUENCY SELECTION
- QUIET TALK (QT)
- QT Tone Setup
- 4 Press the PTT switch to select the 10’s digit of the signalling number
- 5 Wait for 2 seconds to hear the beep pattern of the 10’s digit number you selected .
- 6 Press the PTT switch to select the 1’s digit of the signalling number
- 1 Wait for 2 seconds to hear the beep pattern of the Vs digit number you selected.
- 8 Press the Monitor key to complete the setting.
- QT Tone Setup
- CHANNEL SETTING CONFIRMATION
- TRANSCEIVER FUNCTIONS
- CHARGING THE NiCd BAHERY PACK
- OPTIONAL ACCESSORIES
- TROUBLESHOOTING GUIDE