Installing the antenna – Kenwood TK 3100 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the Antenna
Screw the antenna into the
connector on the top of the
transceiver by holding the
antenna at its base and
turning it clockwise until
secure.
Note: The antenna is neither a
handle, a key ring retainer, nor a
speaker/ microphone attachment
point. Using the antenna in these
ways may damage the antenna and
degrade your transceivers
performance.
Installing the Belt Clip
If necessary, attach the belt
clip using the two supplied
3x8 mm screws.
Note: If the belt clip is not installed,
its mounting location may get hot
during continuous transmission or
when left sitting in a hot environment.
CAUTION: DO NOT USE GLUE
WHICH IS DESIGNED TO PREVENT
SCREW LOOSENING WHEN
INSTALLING THE BELT CLIP. AS IT
MAY CAUSE DAMAGE TO THE
TRANSCEIVER. ACRYLIC ESTER.
WHICH IS CONTAINED IN THESE
GLUES. MAY CRACK THE
TRANSCEIVER’S BACK PANEL
T
L
Antenna
Belt
clip