Kenwood TK 3100 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6 Press the Monitor key to complete the
setting.
• The red LED blinks twice.
7 Press the Monitor key again to
confirm the beep pattern of the
selected frequency number.
8 On the 2 channel model, repeat steps
3 to 7 to set up the other channel.
Example of setting a channel to frequency no. 3:
1 After entering frequency setup mode, select
channel 1.
2 Press the PTT switch 3 times to select frequency 3
(ProTalk™ VHP: Blue/ ProTalk™ UHF: J).
•
A beep sounds each time you press the PTT switch.
3 Wait for 2 seconds to hear the beep pattern of the
frequency number.
•
Three short beeps sound.
4 Press the Monitor key.
•
The red LED blinks twice.
5 Press the Monitor key again.
•
Three short beeps sound to confirm that frequency 3
has been selected.
10