Channel frequency selection – Kenwood TK 3100 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANNEL FREQUENCY SELECTION
You can change the frequency on each channel.
The transceiver will exit the setup mode if no operation
is performed within 5 seconds.
1 Press and hold the PTT switch and
Monitor key, then turn the power ON.
•
Continue to hold the PTT switch and
Monitor key until the LED lights
orange, then release the keys.
2 Press the PTT switch.
•
The LED changes from orange to red
and a beep sounds. The transceiver
is now in frequency setup mode.
3 Use the Channel switch (2 channel
model only) to choose the channel
you want to set up.
4 Press the PTT switch to change the
frequency number.
• Each time you press the PTT switch, a
beep sounds and the frequency
number changes. There are a total of
4 different frequencies (1
4) for the
ProTalk'^'^ VHP and 8 different
frequencies (1 ~ 8) for the
ProTalk™ UHF.
8