Channel setting confirmation, Frequency confirmation, Qt tone confirmation – Kenwood TK 3100 User Manual
Page 22: Channel sening confirmation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANNEL SETTING CONFIRMATION
You can confirm the channel settings of your transceiver
Note: Añer confirming a setting, you must turn the power OFF and then
ON again so the transceiver can operate normally.
■ Frequency Confirmation
1 Select the channel you want to confirm.
2 Press and hold the PTT switch, then turn the
power ON.
• The beep pattern will sound, [i.e.- if freqency 3
(ProTalK™ VHF: Blue./ ProTalk™ UHF: J) is set up
on the channel 3 short beeps will sound.]
Turn the power OFF after confirming the number
3
4
On the 2 channel model, repeat steps 1 to 3 to
confirm the frequency of the other channel
QT Tone Confirmation
Note: There is a short pause between the confirmation of the 10's
digit and the confirmation of the 1 s digit.
1 Select the channel you want to confirm.
2 Press and hold the Monitor key, then turn the
power ON.
• The beep pattern will sound, [i.e.- If QT tone 01 is
set up on the channel a 1 second tone will sound
(0), there will be a short pause, and then a short
beep will sound (1).]
3 Turn the power OFF after confirming the number
4 On the 2 channel model, repeat steps 1 to 3 to
confirm the QT tone of the other channel
16