Installation and connection – Kenwood TM-521E User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. INSTALLATION AND CONNECTION
Warning:------------------------------------------------------------------------
Never apply AC power to the DC Power Supply until
all installation and connections have been com
pleted.
3-1. INSTALLATION
Cautions:-----------------------------------------------------------------------
1.
Do not place the unit in an area that is exposed
to direct sunlight, or near a heater, etc.
2.
Do not store or use the unit in a dusty location or
in a moist atmosphere. Select a well ventilated
location.
3. To maintain good ventilation:
Remove all packing materials.
Do not cover the unit.
Place the unit at least 10 cm (4") away from
the walls.
3-1-1. Mounting Bracket Installation (Mobile)
Warning:------------------------------------------------------------------------
Consider ease of operation and safety when select
ing the location for the Mounting Bracket.
The following tools are required for installing the
Mounting Bracket.
1/6" drill for Self-tapping Screws.
No. 2 Philips Screw Driver.
1.
Select a location in which to install the Mounting
Bracket.
2.
Use the Mounting Bracket as a template to
locate the holes and mark four points to be drill
ed.
Attach the transceiver temporarily using the
SEMS Screws (4 pcs.).
Mounting Bracket
The angle of the Mounting Bracket may be ad
justed to any of five (5) possible viewing angles.
Select the desired angle.
Hold the transceiver in place and tighten the four
(4) SEMS Screws using a wrench or screw
driver.
Warning:-----------------------------------------------------------------
Make sure that the transceiver will not slip out of
place while operating the vehicle.
Mark four points.
Drill four holes as marked using a 1/6" drill for
Self-tapping Screws.
Install the Mounting Bracket using the supplied
Self-tapping Screws (4 pcs.) and Flat Washers
(4 pcs.)
Mounting Bracket
Flat Washer
X
3-1-2. Stacking Plate
(TM-321A and TM-421/521 series only)
To
stack
the
TM-321A,
TM-421
series
and/or
TM-521 series with the TM-221 series, connect
them with the supplied Stacking Plate.
Only one Mounting Bracket will be required so save
the other Mounting Bracket and mounting hardware
for future use.
Select the lower pair of mounting holes on the
bracket as shown in the accompanying diagram
when securing the lower radio.
Self-tapping Screw