beautypg.com

0and (2) up/dwn (up/down) switches, D ptt (push to talk) switch, 0 16-tone dtmf keypad (u.s.a. version only) – Kenwood TM-521E User Manual

Page 11: 2. reception, 2-1. initial control settings, Note

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TM-221A/321A/421A/521A U.S.A. version only

0and (2) UP/DWN (Up/Down) switches

These switches are used to step the VFO frequency

or Memory Channel up and down. The frequency will
change continuously if the switches are pressed and
held.

(D PTT (Push To Talk) switch

The

transceiver

will

be

placed

into

transmit

whenever this switch is pressed. Operations such as
scanning will be cleared when this switch is pressed.

0

16-Tone DTMF Keypad (U.S.A. version only)

Used to activate the DTMF encoder. See Section 4-6
REPEATER for additional information on this item.

4-2. RECEPTION

4-2-1. Initial Control Settings

1. Connect the power supply and antenna and then

set the witches and controls as follows:

POWER switch : OFF
POWER switch of the DC power supply

(Fixed Station)

VOL control
SQL control

OFF
Fully counterclockwise

Fully counterclockwise

2.

Turn on the DC power supply and then press the

POWER switch on the radio; the display will in­

dicate a frequency.

3.

Adjust the VOL control clockwise until a signal

or noise is heard.

4.

Rotate the TUNING control and select an open

channel. Then turn the SQL control clockwise
until the noise just disappears.

5.

Select the desired frequency using the TUNING

control or UP/DWN switches on the microphone.

(See Section 4-2-2 Frequency and Memory
Channel Selection.)
If a signal is received, the BUSY indicator will

turn on and the S-meter will deflect.

6.

To turn off the transceiver, turn off the

transceiver's POWER switch before you turn off
the power supply, or if in a vehicle, before you

stop the engine.

Note:-----------------------------------------------------------------------

The TM-221A front panel is used for illustration

purposes.

Note the initial factory delivered settings for Fre­
quency, Tone Frequency, Memory Channel and

Frequency Step are shown in the accompanying

table.

TM-221A

TM-221ES

TM-321A

TM-421A

TM-421ES

TM-521A

TM-521E

VFO Frequency

144.000 MHz

220.000 MHz

440.000 MHz

(U.S.A version)

430.000 MHz

1240.000 MHz

430.000 MHz

Frequency Step

5 kHz

12.5 kHz

20 kHz

25 kHz

Memory Channel

Memory Channel 0

Memory Channel

144.000 MHz

220.000 MHz

440.000 MHz

(U.S.A. version)

430.000 MHz

1240.000 MHz

430.000 MHz

Tone Frequency

88.5 Hz

88.5 Hz

88.5 Hz

n

This manual is related to the following products: