Kenwood TM-521E - Manual (Page 23)

■ SW-200A/200B SWR/POWER METER (supplied
with a coupler)
SW-200A supplied with SWC-1. SW-200B supplied
with
SWC-2. Selectable peak-reading/RMS.
SWR/POWER meters cover 1.8 ~ 1 50 MHz (SW-
200A), 140 — 450 MHz (SW-200B) in range of
0-20/200W, full scale for base station use.
SW-200A/200B
■ SWC-4 DIRECTIONAL COUPLER
The SWC-4 Directional Coupler is designed for use in
conjunction with the SW-200A/200B SWR/POWER
Meters to cover 1200 — 1300 MHz, The coupler is
capable of handling a maximum input of 20 W.
■ SW-100A/100B SWR/POWER METER
Compact and lightweight SWR/POWER/VOLT
m e t e r s c o v e r 1 . 8 — 1 5 0 M H z ( S W - 1 0 0 A ) ,
1 4 0 - 4 5 0 MHz (SW-100B) in range of 1 50W full
scale for mobile use.
SW-100A/100B
■ RC-10 REMOTE CONTROLLER
The RC-10 Remote Controller provides the following
functions.
1. Direct entry of the desired Transmit/Receive Fre­
quencies using the numeric keypad.
2. Transmit/Receive Frequency or Memory Channels
up or down control.
3. 16-key autopatch operation.
4. Volume control
5. Squelch on or off control.
6. When connected to two transceivers allows
duplex communications.
7. ALT System operation (TM-521 series only)
For additional information, please refer to the In­
struction Manual provided with the RC-10,
■ SWT-1/SWT-2 ANTENNA TUNING UNIT
The SWT-1 (2m band) and the SWT-2 (70 cm band)
are an antenna tuning unit designed for use in con­
junction with an SWR/POWER meter to allow effi­
cient transmission. This unit is especially convenient
for m o n i t o r i n g S W R , u s i n g a K E N W O O D
SWR/POWER meter.
SWT-1/SWT-2
RC-10
■ MB-201 MOBILE MOUNT
The mobile mount MB-201 allows easy installation
and removal of the TM-221/421/521 series and
TM-321A.
■ PG-4G EXTENSION CORD
May be used with the RC-10 to connect a second
transceiver for duplex operation.
■ PG-3B DC LINE NOISE FILTER
May be used with the TM-221/421/521 series and
TM-321A to suppress ignition noise.
PG-2N EXTRA DC POWER CABLE
23