Brother FAX-60 - Manual (Page 27)

21
4. Press the START/COPY button to print out the current security code. You will see:
**************,
CURRENT TAD SECURITY CODE****************
*
TAD SECURITY CODE: 000
************************* ************************
BROTHER FAX-60
5. To register a new TAD Security Code, say, 104, press FINE/PHOTO button once to
select the first digit "1".
6. Press START/COPY button to register this digit.
7. Press START/COPY button (don't touch the FINE/PHOTO button) to register "0".
8. Press FINE/PHOTO button four (4) times to select the final digit "4"
9. Press START/COPY button to register this final digit and the FAX-60 will
automatically print out:
**** DO YOU WISH TO MAKE THE FOLLOWING CHANGE?
*
* NEW TAD SECURITY CODE: 104
*
* * * * * * * * * * * * * * * * * * * * * * * * * * * F A X “ 6 0 ^
*******
■\******************************
The START/COPY lamp will start to blink when the printout is finished.
10. If your entries are incorrect, press the STOP button and then the START/COPY
button. The FINE lamp will start to blink. This will bring you back to step 3 where you
can select this procedure all over again.
If your entries are correct, press the START/COPY button to complete the selection of
numbers. Now you have two choices. Choice (1) allows you to continue with
registration of other parameters. To do so, you press START/COPY button again
which will bring you back to step 3 above and where you can use the FINE/PHOTO
button to select the desired parameter. Choice (2) is to terminate the registration
process by pressing the
STOP button.
G. How to change the number of ICM
The unit is capable of recording a total of 112 seconds worth of messages and memos. You
have a choice of seven (7) 16-second message or four (4) 28-second messages. This choice is
made by the switch on the lower front of the control panel.
H. The TAD and the auto-recelve functions
If you have not set both, the TAD and the AUTO RECEPTION functions on your unit and
some-one is calling your unit, these units will, after fifteen (15) rings:
• Enter the TAD mode after 15 rings if the OGM is recorded and the ICM is not full. The
OGM will start after 15 rings. After completion of this call, the unit will revert to its
original status - no TAD and no AUTO RECEPTION.
or
Enter the AUTO RECEPTION mode if the OGM is not recorded or the ICM is full.