Brother FAX-60 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

14
5.
Press START/COPY button to enter the selection.
6
.
Now, you can change the factory setting of "0" to the optional setting of "1". To enter
"1",press FINE button once. Press START/COPY button to register this choice.
(Note that pressing theSTART/STOP button without pressing FINE/PHOTO button
beforehand, selects and registers a "0"). The unit will automatically print out:
********
**** DO YOU WISH TO MAKE THE FOLLOWING CHANGE?
*
*
*
NEW USER SWITCHES: 01000001
*
*
*****************************gP^Q-|-j_|^
py|^^_0Q*****************************
The START/COPY lamp will start to blink.
7.
If your entries are
incorrect,
press the STOP button and then the START/COPY
button. The FINE lamp will start to blink. This will bring you back to step 4 where you
can select this procedure all over by pressing the FINE/PHOTO button five (5) times
and then going throrough the rest of the procedure.
If your entries are
correct,
press the START/COPY button to complete the selection of
numbers. Now you have fwo choices. Choice (1) allows you to continue with
registration of other switches. To do so, you press START/COPY button again which
will bring you back to step 4 above and where you can use the FINE/PHOTO button to
select the desired switch. Choice (2) is to terminate the registration process by
pressing the STOP
button.
NOTE: Your entries, e.g., the RTI/TTI and user switch, etc. can be verified by printing out the
SYSTEM CONFIGURATION LIST. We will explain how to do this in a later section.