F. setting the tad security code – Brother FAX-60 User Manual

Page 26

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

FUNCTION

COMMAND

DESCRIPTION

Play back message/memo # 1 0

All messages

• Pressing * while message/memo is playing will bring you forward to the following

message/memo.

Erase message/memo

#20

All messages

# 2 1

First message

#22

Second message

#23

Third message

• You may continue this until #24 if the ICM switch (iower front of the unit) is set for four

(4) 28-second messages.

• You may continue this until #27 if the ICM switch (lower front of the unit) is set for

seven (7) 16-second messages.

Record message/memo

Record/Change OGM

Playback OGM

NOT USED

TAD OFF

TAD ON

NOT USED

Terminate Remote Control

#30

# 4 0

# 4 1

#50

#60

#70

# 7 1

# 8 1

#90

Record new message at once

Turns the TAD off.

Turns TAD on.

Terminates the operation. If you do not
order this termination, the unit will cut
the connection automatically in 30
seconds unless you issue another
command.

NOTE:

A short beep is heard repeatedly for 30 seconds when each function has been

completed. To continue with another function, press # within 30 seconds after a 1 sec. beep.

Setting the TAD security code

The TAD security code is a three digit number that is designed to prevent unauthorized remote
access to the messages recorded on your TAD. The factory setting is

000.

To set your own

code, follow this procedure:

Turn the power OFF.

"CAUTION:

BOTH ICM AND OGM MESSAGES WILL BE ERASED IN THE EVENT

OF A POWER INTERRUPTION. CARE SHOULD BE EXERCISED WHEN
UNPLUGGING THE UNIT OR TURNING OFF THE UNIT'S MAIN POWER SWITCH."

Press the

HOOK

button and keep it depressed until

FINE

lamp blinks as you turn the

power back ON.

Press the

FINE/PHOTO

button four (4) times to select the TAD Security Code Set

Mode.