D. erasing the messages/memos, E. remote operation of the tad – Brother FAX-60 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

To skip to the next message, press the

MEMO

button while a message is playing. The unit will

emit a 1 -second beep before the next message.

if you need to stop the playback of a caller's message or a memo, press

MEMO

and

STOP

buttons during the playback or during the beeping between the messages or memos.

If you had to stop listening to recorded messages

during a message-separating beep,

and you

now wish to resume listening, you can do so in two different ways:

Pressing the

MEMO

button once will play back the messages from the top of the very

first message.

Pressing the

MEMO

and

START/COPY

buttons together will let you resume the

playback just before the point where you've stopped earlier.

If you had to stop listening to playback in the middle of a message —

Pressing the

MEMO

button will start you off at the very beginning of the recorded

messages.

Pressing the

MEMO

and the

START/COPY

buttons will start you off with the

message which was interrupted.

Erasing the messages/memos

Make sure that the

TAD

switch is OFF.

To erase a message or a memo press the

FINE/PHOTO

and

RECORD

buttons simultaneously

while the message or memo is playing or during the beep following this message. You will hear a

1 -second beep and the message or memo will be erased.

To erase all messages or memos, press

FINE/PHOTO

and

RECORD

buttons when the message

or memo is not playing. You will hear a 3-second beep.

Remote operation of the TAD

The messages recorded on your FAX-60 TAD can be retrieved from any touch-tone telephone,
provided, you know the security code (to be described below in F). This is how the remote
operation works:

Dial the telephone number of your FAX-60 unit.

When you hear the OGM (your Outgoing Message), press the # button repeatedly until

you hear a short beep (1 second).

Dial in the 3-digit Security Code within 15 seconds of hearing the beep. If the code is

correct, you will hear a short beep (1 second). If the code is incorrect, you will hear a
series of short beeps. Try again!

IMPORTANT NOTE:

If there are no messages on your TAD, you will hear a series of short

beeps.

Now, you are ready to request the FAX-60's TAD to perform some functions. These functions
and the remote commands needed to activate them are shown in the table below.