beautypg.com

About fax machines, Fax tones and handshake – Brother Fax-170 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

C U A

V

T K R 0 N I-

About Fax Machines

If you’re a first-time fax machine user, fax operation might seem a little

mysterious. You’ll soon get used to the unusual fax tones on your phone line, and

be able send and receive faxes easily.

Fax Tones and Handshake

When someone is sending a fax, the fax machine sends fax calling tones, (CNG

tones) — soft, intermittent beeps at 4-second intervals. You’ll hear them v^^hen

you dial and press (^, and they continue for 30 seconds after dialing. During
that time, the sending machine must begin the “handshake” with the receiving
machine. Each time you use automatic procedures to send a fax, you are sending
CNG tones over the phone line. You’ll soon learn to listen for these soft beeps each
time you answer a phone on your fax line, so you can know if you are receiving a

fax message.

The receiving fax responds with fax receiving tones — loud, chirping sounds, A
receiving fax chirps for 40 seconds over the phone line, and the screen displays

“RECEIVE.” If your machine is set to the FAX ONLY Mode, it will answer every call
automatically with fax receiving tones. Even if the other party hangs up, your fax

machine continues to send the “chirps” for 40 seconds, and the screen continues

to display “RECEIVE.” To cancel the receiving mode, press

When your fax machine is in FAX/TEL (F/T), it answers with a short beep. After
this beep, the fax machine listens for CNG tones, and then responds with receiving

tones.

The fax “handshake” is the time in which the sending machine’s CNG tones and

the receiving machines “chirps” overlap. This must be for at least two to four

seconds, so the fax machines can understand how each is sending and receiving
the fax. The handshake cannot begin until the call is answered, and the CNG
tones only last for 30 seconds after the number is dialed. Therefore, it’s important
for the receiving machine to answer the call in as few rings as possible.

When you have a telephone answering device (TAD) on your fax line, your TAD will

determine the number of rings before the call is answered. Pay special attention to
the directions in the Installation chapter for connecting a TAD to your fax machine.

This manual is related to the following products: