Brother Fax-170 - Manual (Page 13)

I N S T A I 1 . A T 1 0 N
Choosing a Location
Place your fax machine on a flat, stable surface, such as a desk. Select a place
that is free of vibration and shocks. Locate the fax machine near a telephone jack
and a standard, grounded power outlet.
Avoid placing your fax machine in a high-traffic area. Do not place near heaters,
air conditioners, water, chemicals, or refrigerators. Do not expose the fax machine
to direct sunlight, excessive heat, moisture, or dust. Do not connect your fax
machine to electrical outlets controlled by wall switches or automatic timers.
Disruption of power can wipe out information in the unit’s memory. Do not
connect your fax machine to electrical outlets on the same circuit as large
appliances or other equipment that might disrupt the power supply. Avoid
interference sources, such as speakers or the base units of cordless phones.
Assentbly
See
Instructions
printed
inside
paper bin
Load the recording paper
^ Lift up the cover by placing your finger in the groove under the arrow in the
front center of the cover, and lift up.
2
Puli the release lever (blue) on the print head unit so that you can lift it up
and remove the recording paper.
3
Remove the three pieces of protective paper.
4
Take the new roll of recording paper out of its wrapper. If you are replacing a
roll, you must remove any paper remaining in the machine.
5
Insert the new recording paper into the paper bin, with the paper feeding
from the bottom of the roll.
6 Insert the edge of the paper into the slot between the roller and the plate.
Feed the paper through until you can see it come out the front of the
machine. Keep the paper stretched tightly.
7
-
Push the release lever (blue) down, then close the cover.