Ignitor battery installation - see fig. 10, Electrode check - requires an assistant – Kenmore 141.15227 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Ignitor Battery Installation - See Fig. 10
1. Unscrew the Ignitor Cap located on the grill
Control Panel and remove the Contact and
Spring from the Ignitor Slot.
2.
Place the manufacturer supplied AA battery
into the Ignitor Slot. Be sure to place the
positive pole facing toward you. See Fig. 10.
3. Plaoe the Spring over the AA battery, then
place the Contact on top of the Spring,
Screw the Ignitor Cap back onto the grill
Control Panel,
4. Remove all protective film from outside and
inside of Grill Head, IMPORTANT; Before
use of this grill please refer to Cleaning
Exterior Stainless Steel Surfaces found on
page 18 of this Owner’s Manual.
Figure 10
Electrode Check - Requires an Assistant
Before plaoing the cooking components into your
grill, ensure that the Spark Electrode Tip is properly
positioned within each Gas Collector Box (a
3-1/4" wide stainless mechanism found at the front
between each set of Burners,) The easiest way to
ensure this is to perform this Electrode Check:
1. Be sure all Control Knobs are set to "OFF"
and open the Grill Lid,
2.
Have an assistant stand behind to the right of
the grill and look down at each Gas Collector
Box, NEVER put your face inside Grill Head,
3. Press the Ignitor Cap. You should hear a
"clicking" sound and your assistant should see
a small blue spark within each Gas Collector
Box. If a spark is present the Electrode Tips
are properly positioned.
4. If no spark is seen the Spark Gap shown in
Fig. 11 needs to be adjusted as follows:
•
Using an adjustable wrench, loosen the Inside Nut
just until the Gas Collector Box oan be maneuvered
and turned upward.
•
The gap between the Spark Electrode Tip and
Spark receiver should be approximately 3/16".
•
If the gap is wider than 3/16" use a pair of long nose
pliers and gently squeeze the Gas Collector Box
until the gap is correct.
•
Return the Gas Collector Box to its original horizon
tal position, secure the Inside Nut and try the
Electrode Check again,
5. If no "clicking" sound is heard check the
following common causes. If you need assis
tance call our Customer Service Helpline
at 1-888-317-7642.
•
Ignitor AA battery not installed properly.
•
Ignitor wires may be loose. Remove the AA battery,
inspect the Ignitor Junction Box found behind the
Control Panel, and connect any loose wires.
Figure 11 - Side View
GAS COLLECTOR BOX
Customer Service Helpline: If you have questions about assembly or grill operation, or if there are
damaged or missing parts when you unpack this unit from the shipping box, call us Sam - 8pm CST,
Monday through Friday at:
1-888-317-7642
13