Kenmore 141.16315800 - Manual (Page 15)

□ Unscrew Ignitor Cap from Control Panel.
□ Place supplied AA battery into the Ignitor
Slot with positive pole facing you.
□ Position the Cap and Spring over the AA
battery and tighten onto Control Panel.
Main Burners Electrode Check
Perform this Electrode Check with the
assistance of another person.
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily
and properly.
Install Ignitor Battery
Spark Gap Gas Collector Box
jH__ 1
r — )
„ T „ . Spark Electrode Tip
Spark Receiver ^
□ Be sure all Control Knobs are set to
"OFF" and open the Grill Lid.
□ Have your assistant stand behind to the
right of the grill and look toward the front
of the grill bowl.
Never put your face
inside the Grill Bowl.
□ Press the Ignitor Cap. You should hear
a "clicking" sound. Your assistant should
see a blue spark within each Gas
Collector Box. If a spark is present the
Electrode Tips are properly positioned.
□ If no spark is seen, the Spark Gap
needs to be adjusted as follows:
• Using an adjustable wrench, loosen the
Inside Nut until the Gas Collector Box can
be turned upward.
• If the gap between the Spark Elec­
trode Tip and Receiver is more than
3/16" use long nose pliers to gently
squeeze the Gas Collector Box to
narrow gap.
• Return the Gas Collector Box to its
original position, secure the Inside Nut
and try the Electrode Check again. If no
"clicking" sound is heard:
• AA Battery may be installed back­
wards.
• Electric wires may be loose. Remove
the AA Battery and inspect the Ignitor
Junction Box found behind the Control
Panel and reconnect any loose wires.
Side Burner and Rôtisserie Burner
Electrode Check
□ Open side burner lid. Remove plastic
shipping band from burner and pot
support.
□ Turn side burner Control Knob to IGN
and push in. Look for spark between tip
of electrode and burner.
□ Open Grill Lid. Turn rôtisserie burner
Control Knob to IGN and push in. Look
for spark between tip of electrode and
burner.
□ If you don't see a spark from side or rôtisserie
burner electrode, adjust gap between
electrode and burner surface to 3/16 in.
Install Cooking Components
□ Place the Heat Diffusers on lower ledge
above Burners.
□ Place Cooking Grids on bowl ledge.
□ Place the Secondary Cooking Rack into
the slots on Grill Bowl Side Panels.
Secondary Cooking Rack
Cooking Grids
Heat Diffusers
Slots for Secondary
Cooking Rack
Model 141.16315800
Final Grill Assembly Step
When you have finished assembling your
grill be sure that all screws are tightened
for safe operation of your grill.
15
Failure to read and follow the Use and Care
Instructions could result in a fire or explosion
that could cause serious bodily injury, death or
property damage.