Kenmore 141.16315800 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

□ Align the 2 holes on Rear Lid Wind Shield with the upper threaded

holes on Rear Lid Wind Shield Bracket. Insert the 2 Phillips Head
Screws 3/16"x5/16" and tighten securely.

Install Lid W ind Shield

///

Phillips Head Screw
3/16''x5/16"
Qty. 2
Part # S275G0305A

Install Side Burner Gas Valve and Side Burner Electrode Wire

□ Cut fastening strap that secures pot support to burner.
□ Insert the Side burner Gas Valve Assembly into Side Burner Tube (See Figure 1). Be sure

the orifice is inside the Burner Tube properly (see warning on Page 3), or lighting the

burner may cause explosion and/or fire.

□ Insert the Side Burner Gas Valve Assembly through the Side Burner Gas Valve Hole on the

Side Burner Frame. Align the 2 holes on the Side Burner Frame with the threaded holes

on the Side Burner Gas Valve Bracket. Then insert 2 Phillips Head Screws M4x8mm

provided and tighten securely.

□ Fasten the Control Knob onto the Side Burner Gas Valve Stem. Be sure that the

OFF position faces the Burner.

□ Push the Socket of Side Burner Electrode Wire into Plug. (See figure 2),

Figure 1

Phillips Head Screw IVI4x8mm
Qty. 2
Part # S112M04082
(Black Painted)

Control Knob for Side Burner
Qty. 1
Part # P03401373H
Scale 1:2