Kenmore 385. 17622 - Manual (Page 7)

SECTION 2. PREPARE THE MACHINE FOR SEWING
Set Up the Machine
• Plug in the Machine and Switch on the Power Foot Contro! Use
machine, be sure the power switch is
OFF.
1. Check your outlet to be sure it is a 110 to 120
Volt AC outlet.
2. Insert the machine plug into the three-prong
plug connector, as shown. It will only fit one
way.
3. Insert the power supply plug into the outlet.
on the power and sewing light.
SAFETY FEATURE:
Your machine will not operate unless the
light/power switch is turned on. If you are
interrupted or stop sewing, turn off the
light/power switch to prevent injury to
children, .......................
OPERATING INSTRUCTIONS ...........
"For appliances with a polarized plug (one blade wider than the other).
To reduce the risk of electric shock, this plug is intended to fit In a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install
the proper outlet. Do not modify the plug in any way."
"Foot Controller Model YC-482P for use with Sewing Machine Models
385.1148XXX, 385.1158XXX, 3a5.1168xxx, 385.1258xxx, 385.1268xxx.
385.12612XXX, 385.1278XXX, 385.11607xxx, 385.12710xxx, 385.12714xxx,
385.12712XXX, 385.17622XXX, 385.11608xxx, 385.12814xxx and 385.12014xxx.
XXX - represents numbers 000 through 999."
{For U.S.A. market only)
100
-
316-005
which you sew.
To increase speed, gently press down with
the ball of your foot.
To decrease speed, release your foot pres­
sure slightly.
The foot control is sensitive and
will increase or decrease your
sewing
speed immediately.
Practice on a scrap of fabric to
regulate your sewing speed to
your taste and needs.