Kenmore 385. 17622 - Manual (Page 20)

SECTION 3. LEARN THE STITCHES
Straight Stitches
• Straight Stitch
Set the Machine
Stitch
Stitch selector
J
Top thread tension
control 2 to 6
Stitch length
control red
zone
•3~
Raise the presser foot.
Raise the needle to its highest
positieo,............ -.... --.........._...____.
3.
4.
5.
6 .
Place the edge of the fabric next
to a stitching guide line on the
needle plate |5/8" is most
common).
Draw the threads towards the
back and lower the presser foot.
Press the foot control.
Hold the fabric loosely and gently
guide it along the guide line, so
that it feeds naturally.
Do not force the fabric or try to
pull it tight.
7. At the end of the seam, you may
want to rewerse to lock the stitch.
8. Raise the presser foot and remove
the fabric, .....
9. Cut the threads.
Use the Seam Guides
are there to help you measure seam
width. The lines are 1/8" apart, with
the 5/8" and 7/8" lines marked.
• Tuoij^guMe Corner...
18
fabric edge:
1.
Stop stitching and lower the
needle by turning hand wheel
toward you when the fabric edge
facing you lines up with the
cornering guide, as shown.
2. Raise the presser foot and turn
the fabric to line the edge with
the 5/8" seam guide.
3. Lower the presser foot and begin
stitching in the new direction.