Kenmore 73511 - Manual (Page 20)

i вс I
Control, Clock and Timer
Clock
The clock m ust be set for autom atic oven timing
functions to work properly, i he tim e of day cannot be
changed during a TIM E BAKE or CLEAN cycle
To Set the Clock:
Step 1. Touch
word “TIME” wil the CLOCK pad. The
I flash in the display
Step 2. Press & hold or tap INCREASE
or DECREASE pad to set the time of
day. (Tap to change tim e 1 m inute a tap.
Press & hold to change time 10 m inutes
at a tim e)
Example: Try setting the tim e for 3:00, Use a com bi­
nation of presses and taps to get fam iliar with the con­
trol Since this is a 12-hour clock, there is no need to
worry about AM or PM.
if you accidentally go past 3:00, sim ply
press & hold or tap the DECREASE pad
until the tim e shows in the display
in Cass of Power Outage:
After a power outage, when power is restored the dis-
piay will fiash and tim e shown will no longer be cor­
rect
Display flashes until clock is reset. All other functions
that were in operation when the power went out will
have to be programm ed again,
Titnar
The tim er does not control oven operations. The m ax­
im um setting on the timer is 9 hours and 55 m inutes
To Set Ths Tim er:
Step 1, Touch the TIMER pad The word
“TIMER” will flash in the display.
Step 2. Press & hold or tap INCREASE or DE­
CREASE pad to set the amount of time on tim sr
(Pressing & holding the pad changes tim e in large
am ounts Short taps change time in sm aller amounts,)
The tim er wilt start autom atically within a tew seconds
of releasing the INCREASE or DECREASE pad
The tim er, as you are setting it, will display seconds
until 60 seconds is reached. Then it will display min­
utes and seconds until 60 m inutes is reached. After 60
m inutes, it will display hours (“HR" now appears in
display) and m inutes until the m axim um tim e of 9
hours and 55 m inutes is reached
To Reset Timer:
Touch TIM ER pad and then press & hold or tap
INCREASE or DECREASE pad until desired time is
reached
To Cancel Timer:
Press & hold TIM ER pad until the word “TIMER” quits
flashing on the display (about 4 seconds).
Tones
The end-of-cycie tone will sound at the end of tim e
oven functions. The end-of-cycle tone is a steady sig­
nal that repeats every 6 seconds until you touch any
operation If you would like to change the tone to a set
of 3 short beeps, press & hold CLEAR/OFF for 10
seconds-
To return the end-of-cyde tone to a steady repeating
signal, press & hold CLEAR/OFF for 10 seconds,
Display
Program med information can be displayed at any tim e
by touching the pad of the operation you want to see
For exam ple, you can display the current tim e of day
while the tim er is counting down by touching the
CLOCK pad
“door” appears on display. The oven door is in the
locked position. BAKE, BROIL and COOK TIM E can­
not be set if the door is In the locked position,
“F-” and a number flash on display. This is the
function error code. If function error code appears
during the self-cleaning function, check oven door
latch— the latch handle may have been m oved, even
if only slightly, from the latched position. Make sure
handle is to the right as far as it will go. Touch
CLEAR/OFF pad If function error code does not
clear, disconnect power to the range and call for ser­
vice
19