beautypg.com

Convert the oven burner orifice for lp gas, Adjusting the air adjustment shutters for lp gas, Installation instructions – Kenmore 73511 User Manual

Page 13: Step 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Installation Instructions

(continued)

s t e p s

Convert The Oven Burner Orifice
For LP Gas

Oven Burner:

1.

Remove oven door, storage drawer, oven bottom

and burner baffle. The burner orifice spud is located
behind a m etal shield at the center bottom of range.

2. Remove m etal shield and use a 1/2" wrench to turn
the burner orifice spud clockwise Tighten spud only

until it is snug with the base. To prevent leakage, do
not overtighten spud or ioosen spud after it is snug

Broil Burner:

Use a 1/2" wrench to turn the upper burner orifice
spud clockwise. Tighten spud only until it is snug with

the base, To prevent leakage, do not overtighten spud
or loosen spud after it is snug

Step 4

Adjusting The Air Adjustment Shutters

For LP Gas

For location of and access to air adjustm ent shutters
see page 8.

Loosen the Phillips head
screw and rotate the shutter

to the full open position. W ith

baffle in place, flames should
have approxim ately l-inch
blue cones and should not

screw

extend beyond the edges of
the burner baffle For LP AirShuuer
gas, this should occur when
the air adjustm ent shutter is
com pletely open. After 30
seconds of burner operation, check for flames lifting
off burner ports. If lifting is observed, gradually reduce
air shutter opening until flam es are stabilized,

12

This manual is related to the following products: