beautypg.com

Leveling the range, Step – Kenmore 73511 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

To remove the oven bottom ;

1. Remove knurled screws holding down rear of oven
bottom.

2. Grasp oven bottom at finger slots on each side

3. Lift rear of oven bottom enough to dear the lip or

range fram e, then pull out.

To remove the burner baffle:

1. Use a nut driver to rem ove the 1/4” hex head screw

shown in the illustration above. Do not rem ove any
other screws

2. Pull baffle straight out until it is free from the slot that

holds it at rear of oven.

Step ?

Leveling the Range

1.

If necessary, rem ove storage drawer, Pull drawer

out ait the way and lift front of drawer up to rem ove

2. Use a 3/16" open-end or socket wrench to back out
both rear leveling legs approxim ately two turns.

3. Use a 1% ” open-end or adjustable wrench to back
out the front leveling legs two turns

4. install the oven shelves in the oven, position the

range where it will be Installed

5. Check for levelness by placing a spirit level or a par­
tially filled cup of water on one of the oven shelves, if

using a spirit levei, take two readings— with the level
placed diagonally first in one direction and then the other

6

. Adjust the leveling legs until the range is level.

7.

After the range is level, slide the range away from

the wall so that the Anti-Tip device can te installed

(continuBd next page)

This manual is related to the following products: