How to install and rlmovf panes, A warning, A caution – Kenmore 596.50002100 User Manual
Page 9: Note, Installing panels, Removing panels, How to install and remove panels
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO INSTALL AND
RLMOVf PANES
A WARNING
To avoid possible injury and damage
to property, tape decorative panels
(some models) securely into place
when door handles are removed.
A CAUTION
To avoid personal injury or
property damage, observe the
following:
Refrigerator panels should not
weigh more than 30 pounds (14
kilograms) and freezer panels
should not weigh more than 15
pounds (7 kilograms).
> Protect soft vinyl or other flooring
with cardboard, rugs or other
protective material.
> Protect hands and arms by
wearing gloves.
NOTE:
>> To protect door surfaces from being
scratched, cover back edges of
decorator panels by placing masking
tape along back edges.
5^ Save all screws and reuse in original
locations.
'/4" (6 mm) Panel Dimensions
Extended
Door
Panel
Panel
Height
Panel
Width
Fresh food
door
66 %"
(169.5 cm)
18'y,6"
(48.1 cm)
Upper
dispensing
freezer door
18
Vs"
(46 cm)
13’V
(35.4 cm)
Lower
dispensing
freezer door
32 %2"
(81.5 cm)
13'y,6"
(35.4 cm)
Non
dispensing
freezer door
66
%"
(169.5 cm)
13%"
(35.4 cm)
INSTALLING PANELS
1
. Remove top trim screws with a
Phillips screwdriver and remove top
trim.
2. Slide handle upward until
loose. Remove handle
from door.
3. Remove door
retainer clips with
a
'/4"
hex head
driver.
4. Slide bottom of panels Into bottom
door trim until hinge side of decorator
panel rests under hinge side trim.
IMPORTANT:
Tape tops of panels to
door to prevent panels from falling.
5. Reinstall door
retainer clips with
a '/
4
" hex head
driver.
6
. Reinstall handle by inserting retaining
clips on door into notches on back of
handle.
> Slide handle down until it contacts
bottom trim.
Ji
7. Remove tape from
tops of panels
before reinstalling
top door trim with
Phillips screws
removed in step 1.
REMOVING PANELS
1
. Remove top trim screws with a
Phillips screwdriver and remove top
trim.
IMPORTANT:
Tape tops of panels to
door to prevent panels from falling.
2. Slide handle upward until
loose. Remove handle
from door.
3. Remove door
retainer clips with
a Vi" hex head
driver.
4. Remove tape to slide panels out of
door trim.
5. Refer to steps 5, 6 and 7 of
Installing Panels
to install handles
and trim.
O
X
9