Iksimlm your rffrkm, Measuring the opening, Reerigerator – Kenmore 596.50002100 User Manual
Page 6: Selecting the best location, Ransporting, Your
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

IKSIMLM YOUR RffRKM
These instructions were provided to aid
you in the installation of your
refrigerator.
MEASURING THE OPENING
When installing your refrigerator, please
reference chart below for clearance
requirements.
Subflooring or floor coverings (i.e.
carpet, tile, wood floors, rugs) may make
your opening smaller than anticipated.
Some clearance may be gained by
using the leveling procedure under
How to Level Your Refrigerator
(page 11).
Unit Total
Volume
Recommended
. Clearance
Top
Sides
Rear
Less than
23 cu. ft.
N/A
N/A
'/
2
"
Greater than
23 cu. ft.
Vi'
N/A
'/
2
"
IMPORTANT;
If refrigerator is to be
installed into a recess where top of
refrigerator is completely covered, use
dimensions from floor to top of hinge
cap to verify proper clearance.
T
ransporting
your
REERIGERATOR
Follow these tips when moving the
refrigerator to final location:
5^
NEVER
transport refrigerator on its
side. If an upright position is not
possible, lay refrigerator on its back.
Allow refrigerator to sit upright for
approximately 30 minutes prior to
plugging refrigerator in to assure oil
returns to the compressor. Plugging
refrigerator in immediately may cause
damage to internal parts.
5^ Use an appliance dolly when moving
refrigerator.
ALWAYS
truck
refrigerator from its side or back-
NEVER
from its front.
3^ Protect outside finish of refrigerator
during transport by wrapping cabinet
in blankets or inserting padding
between the refrigerator and dolly.
> Secure refrigerator to dolly firmly with
straps or bungee cords. Thread straps
through handles when possible.
DO NOT
overtighten. Overtightening restraints may
dent or damage outside finish.
SELECTING THE BEST
LOCATION
Observe these points when choosing the
final location for your refrigerator:
DO NOT
install refrigerator near
oven, radiator or other heat source. If
not possible, shield refrigerator with
cabinet material.
> DO NOT
install where temperature
falls below 55° F (13° C). Malfunction
may occur at this temperature.
> To assure proper door closure, follow
the leveling instructions in the
section,
How to Level Your
Refrigerator
(page 11).
6