Kenmore 596.50002100 - Manual (Page 19)

fIVi-BUTTOH COHTROl HATURiS
I^RUS h J cube "^
DISPENSER
OPERATION
To dispense:
> Select CUBE, CRUSH or WATER
mode by pushing button on dispenser
control panel. A green indicator light
above button shows mode selection.
>■ Press container against dispenser
pad. Selection mode may not be
changed while ice dispenser is in
operation.
NOTE: If water dispenser is
continuously active for more than 5
minutes, an automatic lock out sensor
will shut down power to dispenser area.
For instructions on how to unlock your
dispenser, see the section entitled
Dispenser Lock below.
DISPENSER LOCK @
This feature prevents ice or
water from being dispensed.
To lock and unlock dispenser:
> To lock dispenser, press and hold
LOCK/UNLOCK button for 3
seconds. A green indicator light
above button confirms dispenser is
locked.
> To unlock dispenser, hold
LOCK/UNLOCK button for 3
seconds. Green indicator light above
button will go out.
O GOOD
O CHANGE
FILTER
FILTER STATUS
INDICATOR LIGHT
The filter status indicator light
serves as a reminder to
replace the water filter. A green light
indicates that the filter is in good
condition. A red light indicates the filter
should be changed. Once light turns red,
it will remain red until function is reset.
To reset indicator:
5^ Press and hold both LOCK/UNLOCK
and WATER buttons simultaneously
for 4 seconds. The green filter status
indicator light will flash 3 times when
the function has successfully reset.
AUTO LIGHT
The auto light function
offers the ability to activate the
dispenser light at half-power when the
LIGHT SENSOR detects that the light
levels in room are low.
To activate and deactivate auto light:
5^ To activate, press ON/OFF button
located on control panel. A green
indicator light above button displays
to show that sensor is active.
>- To deactivate, press ON/OFF button.
Green indicator light will go out.
NOTE: Dispenser light will operate
whether or not auto light is selected.
m
z
G)
j -|- j^N/OF^ SABBATH
MODE
This mode is intended to deactivate
power to the LED and dispenser lights,
while allowing the controls to remain
operational.
To activate and deactivate Sabbath
Mode:
To activate, press and hold both
LOCK/UNLOCK and ON/OFF
buttons simultaneously for 3 to 4
seconds. After 3 to 4 seconds, the
LED and dispenser lights will turn off.
Dispenser light will not activate
during dispensing while in this
mode.
> To deactivate, press and hold both
LOCK/UNLOCK and ON/OFF
buttons simultaneously for 3 to 4
seconds. After 3 to 4 seconds, the
LED and dispenser lights will
activate.
NOTE: In the event that power is
interrupted while the Sabbath Mode is
active, the control will remain in Sabbath
Mode when power returns.
19