How to rtmovt odors from refrigerator, Fkergy saying ideas, How to remove and replace light bulbs – Kenmore 596.50002100 User Manual
Page 24: A warning, A caution, Upper fresh food, Section, Lower fresh food, Section b, Freezer section
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

HINTS ÂNDCÀRLcoKT.
HOW TO RTMOVT ODORS
FROM REFRIGERATOR
1. Remove all food.
2. Disconnect refrigerator.
3. Clean the following items-paying
special attention to crevices-using
the appropriate instructions in
How to
Clean Your Refrigerator:
• Walls, floor, and ceiling of cabinet
interior.
• Drawers, shelves, and gaskets.
4. Wash and dry all bottles, containers,
and jars. Discard spoiled or expired
items.
5. Wrap or store odor-causing foods in
tightly-sealed containers to prevent
reoccurring odors.
6. Connect power to refrigerator and
return food.
7. After 24 hours, check if odor has
been eliminated.
If odor is still present...
1. Remove drawers and place on top
shelf of refrigerator.
2. Pack refrigerator and freezer
sections-including doors-with
crumpled sheets of black and white
newspaper.
3. Place charcoal briquettes randomly
on crumpled newspaper in both
freezer and refrigerator
compartments.
4. Close doors and let stand 24-48 hours.
5. Repeat steps 5 through 7 above.
If odor was not eliminated, contact
Sears Service Center. Refer to back of
manual for phone number.
fKERGY SAYING IDEAS
Avoid overcrowding refrigerator
shelves. This reduces effectivity of air
circulation around food and causes
refrigerator to run longer.
> Avoid adding too much warm food to
refrigerator at one time. This
overloads compartments and slows
rate of cooling.
> DO NOT
use aluminum foil, wax paper,
or paper toweling as shelf liners. This
decreases air flow and causes
refrigerator to run less efficiently.
>■ A freezer that is % full runs most
efficiently.
3^ Locate refrigerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances. If
this is not possible, isolate exterior by
using a section of cabinet or an
added layer of insulation.
Refer to section in Use and Care
Guide on temperature controls for
recommended control settings.
> Clean door gaskets every three
months according to use and care
guide instructions. This will assure
that door seals properly and
refrigerator runs efficiently.
3> Take time to organize items in
refrigerator to reduce time that door
is open.
> Be sure your doors are closing
securely by leveling refrigerator as
instructed in your use and care guide.
>■ Clean condenser coils off as
indicated in the Use and Care Guide
every 3 months. This will increase
energy efficiency and cooling
performance.
HOW TO REMOVE AND
REPLACE LIGHT BULBS
A WARNING
To avoid electrical shock which can
cause severe personal injury or death,
disconnect power to refrigerator
before replacing light bulb. After
replacing light bulb, connect power.
A CAUTION
To avoid personal injury or property
damage, observe the following:
>- Allow light bulb to cool.
>- Wear gloves when replacing light
bulb.
UPPER FRESH FOOD
SECTION
1. Locate finger
gaps on each
side of clear light
shield. Insert
fingers and press in on each side of
shield. Pull shield down and remove.
2. Remove light bulbs.
3. Replace with appliance bulbs no
greater than 40 watts.
4. Replace light bulb cover by inserting
front tabs of light shield into slots
directly in front of light assembly.
LOWER FRESH FOOD
SECTION
B
1. Pinch bottom tabs
(A) on light cover
and pull straight
out.
2. Remove light bulb.
3. Replace bulb with appliance bulb no
greater than 40 watts.
4. Insert top tabs (B) of light cover into
liner slots and snap bottom portion
over light assembly.
FREEZER SECTION
1. Remove ice bin by
A
lifting front of bin
and pulling out.
q
\\ ^
B
2. Remove light bulb
cover by pinching top tab
(A) and pulling cover out.
3. Remove light bulb. Replace with
appliance bulb no greater than 40 watts.
4. Insert bottom tab (B) of light cover
into liner slots and snap top portion
over light assembly.
5. Replace ice bin by sliding in until bin
locks into place.
ICE AND WATER
DISPENSER
1. Locate light bulb inside top edge of
dispenser frame. Unscrew to remove.
2. Replace light bulb with a
7-watt, 120 volt bulb.
Ik
3move.
i