Kenmore 596.50002100 - Manual (Page 20)

DKPEHSIRfEAWS,«
aKTimc (MROL
kaiws
DISPENSER Q pi
OPERATION ^ ^ ^
To dispense water:
> Select the WATER button.
Press container against dispenser
pad.
To dispense ice:
> Select the CUBE button for [p
cubed ice.
3^ Press the CRUSH button for [^]
crushed ice.
> Press container against dispenser
pad.
NOTE: If water dispenser is
continuously active for more than 2
minutes, an automatic lock out sensor
will shut down power to dispenser area.
For instructions on how to unlock your
dispenser, see the section entitled
Dispenser Lock below.
DISPENSER LOCK
This feature prevents ice or
water from being dispensed.
To lock and unlock dispenser:
To lock dispenser, press and hold the
LOCK/UNLOCK button for 3
seconds. A green indicator light
above button confirms dispenser is
locked.
> To unlock dispenser, hold the
LOCK/UNLOCK button for 3
seconds. Green Indicator light above
button will go out.
LIGHT FUNCTION ,
I ON/OFF I O s)
The light function offers two
settings: OFF and AUTO.
The OFF setting will turn off the
dispenser cavity light.
The AUTO setting allows the SENSOR
to measure the surrounding light levels
and adjust the power of the cavity light
accordingly. When the sensor registers
lower light levels (night time, darkened
kitchen), the cavity light will respond at
50% power. When the sensor registers
high light levels (lighted kitchen, direct
sunlight), the cavity light will not activate.
NOTE: Dispenser light will operate at
full power when ice or water functions
are in use.
To activate auto setting:
>■ Press the ON/OFF button located on
control panel. When the green
Indicator light above the button
display is on, the cavity dispenser
light will use the AUTO setting.
To deactivate auto setting:
3^ Press the ON/OFF button located on
control panel. Green indicator light
above button will go out.
FILTER STATUS ™
INDICATOR
LIGHT
The filter status indicator light serves as
a reminder to replace the water filter. A
green light indicates that the filter is in
good condition. A red light indicates the
filter should be changed. Once light
turns red, it will remain
red until function is
reset.
To reset indicator:
Press and hold both the LOCK/
UNLOCK and the WATER buttons
simultaneously for 4 seconds. The
green filter status indicator light will
flash 3 times when the function
has successfully reset.
TEMP SET
\/
TEMPERATURE KEYS
These keys will lower or raise the
freezer or fresh food compartment
temperature.
NOTE: See the section How to Adjust
the Temperature Controls (page 12)
for instructions on how to set food
compartment temperatures.
20