To operate suction control slide, Caution, Hill – Kenmore 116.31722 User Manual
Page 9: Slide
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Swivel
The attached
hose swivels to
make cleaning
easier in every
direction.
Remove the
hose trom the
hose clip by
pulling straight
out.
TELESCOPING WAND WITH
SUCTION CONTROL SLIDE
SOME MODELS
Hill
Crevice
Tool
Telescoping
W end
Remove the
telescoping
wand from
its storage
position.
R^ove the crevice tool from its storage
position in the wand. Turn the locking ring to
the UNLOCK position.
Extend the wand to its full length. Turn the
locking ring to the LOCK position. Attach
the extension wand onto the open end ol
the hose.
Suction
Contro/
Slide
W and
\
Locking Ring
Upper
W and
When using the dusting brush or the combi
nation brush, they may be attached directly
to the wand or placed on the end of the
crevice tool.
Align the tabs on the extension wand with
the "J" slots in the hose. Push the wand into
the hose and twist to the right to lock,
To achieve maximum
reach with the attach
ments, add the crevice
tool to tlto ond o(
the wand by
Rose -
inserting
and twist
ing slightly.
slide
X
Telescoping
Wand^^^^"
TO OPERATE SUCTION
CONTROL SLIDE
Telescoping Wand
When using attachments for cleaning
draperies, small rugs with low pile and other
delicate items, twist the suction control slide
to the open position. This lever is located on
the telescoping wand, close to the hose.
Tills will
reduce
suction for
ease of
cleaning.
NOTE: Return suction control slide to the
closed position for normal cleaning.
CAUTION
When using attachments, be careful
not to overextend the stretch hose
when reaching.Trying to reach
beyond the hose stretch capability
could cause the cleaner to tip over.
Make sure the carpet/bare floor
selector is in the bare floor position.
Damage to the floor surface may
occur if the carpet setting is used.