Warning, To remove belt, Belt changing and warning – Kenmore 116.31722 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BELT CHANGING AND
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec
trical shock or personal injury from
cleaner suddenly starting.
Frequently check and remove hair, string
and lint build-up in the brush area, if build
up becomes excessive, follow the steps
below.
TO REMOVE BELT:
Disconnect power cord from electrical out
let.
Place the
carpet/bare
floor selec
tor in the
carpet posi
tion and
lower han
dle to lay
vacuum flat.
Slide latches
outward and
remove nozzle
cover.
Unfasten the
furniture
guard retain
ers from the
posts on both
sides of the
agitator
cover.
Depress tabs on
rear of agitator
cover and rotate
forward to
release from ttm
nozzle body.
The tight bulb socket assembly does not
have to be removed. Lay the agitator cover
over to the side out of the way.
Position hands on the agitator. If the belt is
still attached to the agitator, there will be
tension on the agitator. Carefully lift the right
end of the agitator and then the left end.
NOTE: It may be necessary to pull the edge
of the furniture guard out of the way to allow
the ends of the agitator to be removed easi
ly.
Remove the belt from the motor drive shaft,
A spare belt is provided. See above illustra
tion for location of spare belt. You may keep
a spare belt in this location any time.
WARNING
Personal Injury Hazard
Be careful when removing the agita
tor as the belt tension is high.
Failure to do so could result in per
sonal injury from the agitator releas
ing quickly and snapping away.
17