Cord assembly, Operating instructions, Howto start – Kenmore 116.31722 User Manual
Page 6: Warning, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CAUTION
Do not overtighten.
Overtightening could strip the screw
holes.
Do not operate the cleaner without
the screw in place.
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position, Remove the
wire tie from the power cord.
Lock Ilio cord Into
place by forcing it
into the locking
notch on the body of
the quick release
upper cord hook as
shown. This helps
keep the power cord
out from under the
vacuum cleaner agi
tator.
Power
Cord-
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord.
Quick Release
Upper Cord
Hook
OPERATING INSTRUCTIONS
HOWTO START
Turn the quick
release upper
cord hook to
either side
and down to
release the
power cord.
Release the power cord plug from the
power cord and pul! the cord off the quick
release upper cord hook. Check to be sure
the power cord is still locked into the lock in
the quick release upper cord hook.
NOTE; To reduce the risk of electric shock,
this vacuum cleaner has a polarized plug,
one blade is wider than the other.
This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit,
contact a qualified technician to install the
proper outlet. Do not change the plug in any
way.
Plug the polarized power cord into a 120
Volt outlet located near the floor.
WARNING
Personal Injury and Product Damage
Hazard
• DO NOT plug In if switch is in the
ON position. Personal injury or dam
age could result.
• DO NOT use outlets above coun
ters. Damage to items in surrounding
area could occur.