Canon VC-C50iR - Manual (Page 72)

Camera Settings
34
MA I N MENU
SET MENU
D I SP MENU
CA E MENU
NEXT SET
LAY
RA M
BACK CANCEL NEXT SET BACK CANCEL
NEXT SET BACK CANCEL
SET MENU
RS - 232C ETT I NGS . . S
REMO O O NTR R TE C LLE I D 0
C
RESTORE DEFAULT
O D E - C4 V MOD AN MM
RS - 232C TT I NGS SE
BAUD ATE 0
1
0 6 9 R
RS - 232C TT I NGS SE
BAUD ATE 0 0 8 4
0 0 6 9
0 0 4 4 1
0 0 2 9 1
R
STOP
DA
NON PAR I TY
TA I T N O LY E R AD
N O LY E R AD
NEXT SET
T B I
8 B
RS - 232C TT I NGS SE
BAUD ATE 0
1
0 6 9 R
STOP
DA
NON PAR I TY
TA I T N O LY E R AD
N O LY E R AD
T B I
RS - 232C TT I NGS SE
1
2
STOP T B I
8 B
BACK CANCEL SET SET CANCEL CANCEL
SET SET CANCEL CANCEL
C
● For information on items other than the RS-232C SETTINGS item on the SET
MENU, see below.
(1) See page 35 for information on the REMOTE CONTROLLER ID setting.
(2) COMMAND is set when using the VC-C50i/VC-C50iR in Canon
Communication Camera VC-C3 mode
(→ P.33).
(3) To restore the default values for the settings (
→ P.40), select [SET] in the
RESTORE DEFAULT setting.
MEMO
RS-232C Settings
These settings are used for controlling the VC-C50i/VC-C50iR from a PC or other device. The
DATA 8 BIT and NON PARITY settings are fixed, and the menu is used to check them only.
DATA 8 BIT and NON PARITY are to be read only.