Kenmore ASPIRADORA 116.29914 - Manual (Page 8)

CANISTER
1. Open the canister hood,
2. Check to see that the dust bag Is property
instated. See BAG CHANGING for
instructions
3. Check to see that the motor safety filter is
properly installed. See MOTOR SAFETY
FILTER CHANGING for instructions,
HOOD AND TOOL
STORAGE COVER
It is normal for the canister hood and tool
storage cover to come off when opened
further than needed. Line up the hinge slots,
insert the hinges into the slots, and dose the
hood and tool storage cover to reinstall.
.CAUTION
Never open canister hood with the tool
storage cover open. This will help to
prevent damage from occurring to the
canister hood and/or tool storage cover.
HOSE
1. Line up the hose
latch tab and notch
in canister hood
and insert hose
into canister until it
snaps into place
Hose
Latch
Tab
Notch
To remove: Do not open hood before
removing hose. With hood dosed, depress
hose latch tab and pull upward on hose
2. Insert handle
into wand until
\ lock button
I snaps in place,
\ I ^Handle
Be sure hose is
not twisted.
Lock S
To remove:
Handle ( ______ l[~] Press handle
Quick
R e i e a s e — / ‘
quick release
button and pul!
up on handle.
To store: Disconnect hose from wand and
canister to prevent stress on hose during
storage. Store hose in a loosely coiled
position so the hose covering is not stressed.
PET POWERMATE STORAGE
This canister is equipped with an on-board
storage area for a Pet PowerMafe
attachment
To Install:
Open the Pet PowerMate storage cover,
insert the Pet PowerMate, press down into
place, and close the lid securely.
To Remove:
Open the storage cover, Remove Pet
PowerMate from the storage area and use
as needed {see ATTACHMENTS and
ATTACHMENT USE TABLE),
Pet PowerMate