Stair grip, Waifjd light, Check bag indicator – Kenmore ASPIRADORA 116.29914 User Manual
Page 14: Electronic suction control, Mechanical suction control, Thermal protector
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STAIR GRIP
During normal operation while the canister is
in the horizontal position, the caster wheel
rotates freely 360°.
; er to prevent
mister from
|g cjn stairs,
TAIR GRIP
tifjally locks
wheel in
'hen the
raised
loiizontal
position.
WAIfJD LIGHT
This vacuum cleaner is
equipped with a light on the
extension wand. This light
will operate only when the
vacuum cleaner is in
'~
q
4\
/ CARPET mode (see HOW
TO START) , The light will
operate when attached or
not attached to the
Poweryate
The light can be used for lighting hard to
reach locations .
CHECK BAG INDICATOR
When the vacuum
cleaner is running
with normal airflow,
the CHECK BAG
light is off- The
light comes on
whenever the
airflow becomes
blocked. If that o.
disposable du^
motor safety
CHECK
BAG
indicator-
clog
location
CLOGS
Then check the
and other possibly
hown in REMOVINf
To correct problem: See the TROUBLE
SHOOTING table
NOTE: The light may come on when using
certain attachments, due to reduced airflow
through attachment.
ELECTRONIC SUCTION
CONTROL
The electronic suction control allows you to
change the power of the vacuum cleaner
suction motor.
increase
Suction
I
Decrease
Suction
LOW
POWER
decreases suction
for draperies and
lightweight rugs.
HIGH increases
suction for
upholsteries and
carpets,
MECHANICAL SUCTION
CONTROL
The mechanical suction control allows you
to adjust the vacuum suction for very light
fabrics,
Opening the
control decreases
suction while
closing the
control increases
suction.
THERMAL PROTECTOR
This vacuum cleaner has a thermal
protector which automatically trips to protect
the vacuum cleaner from overheating, If a
prevents the normal flow of air to the
motor, the thermal protector turns the
motor off automatically, This allows the
motor to cool in order to prevent possible
damage to the vacuum cleaner.
Tgxorrect problem: Turn off and unplug
/ifa^cuum cleaner to allow the vacuum
cleaner to coo! and the thermal protector
to reset Check for and remove clogs, if
necessary., Also check and replace any
clogged filters. Wait approximately
thirty (30) minutes and plug the vacuum
cleaner in and turn back on to see if the
motor protector has reset
14