beautypg.com

To clean agitator, Important, Agitator assembly – Kenmore ASPIRADORA 116.29914 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TO CLEAN AGITATOR;

NOTE: in order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every

Clean Agitator

every week

The agitator must also be cleaned accord­
ing to the fallowing schedule:

Vacuum Cleaner Use

HEAVY -

(used daily)

MODERATE -

ever

(used 2-3 times/week)

LIGHT -

every 2 months''

(used 1 time/week)

IMPORTANT

Turn off and unplug vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the

PowerMate agitator and end cap areas.

Remove any dirt or debris in the belt path
area or in the brush roller area,.

Carefully remove any string or debris
located on the agitator or end caps.

AGITATOR ASSEMBLY

End Cap

Bett Path-

.

ÜÎSL

Brush Unit

End Cap'

TO REPLACE BELT

1. tftst^l ne'

belt ovei
motor dri
then over
path.

Belt Path

Agitator End Cap

NOTE: See PARTS AND FEATURES for
Belt number.

2. Place agitator

assembly into
PowerMate.

3. NOTE: On dirt sensor models be sure
that the dirt sensor board is upright and the
wires are tucked back in place,

4. Line up front of cover and base Rest
cover on front edge of base as shown.

5. Rotate cover
back. Press cover

firmly until side

latches snap into
place.

6. Make sure there is no gap between the
cover and base and that the rear latches
are snapped in place.

7. Turn PowerMate upside down and
replace two (2) cover screws.

20

This manual is related to the following products: