To clean the lenses, Caution – Kenmore ASPIRADORA 116.29914 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Although the dirt sensor feature in your
Kenmore PowerMate® is designed for years
of trouble free use, the passage of dirt
through the air passage system can coal the
lenses causing the green light to come on
and stay on - never switching to red. When
this happens the lenses must be cleaned.
.CAUTION
Never use water or any cieatring
solution when cleaning the lenses. The
residue of the water or cleaners will
accelerate the recoatlng of the lenses
and make cleaning necessary sooner.
TO CLEAN THE LENSES
1. Remove the
wand from the
PowerMate by
pressing the quick
release pedal and
lifting up on the
wand.
J.----- - Wand
Quick
Release
Pedal
2. As indicated by the illustration, the two dirt
sensor elements are located on the inside of
the swivel, approximately 3V4 inches/90 mm
down, {note the arrows).. Each element
should be cleaned periodically. To reach the
sensor elements, use a small brush such as
a bottle brush. Brush each sensor element
several times to remove dust and dirt
Cross Section View
Approx.
3 ii inches
or 90 mm
Ring
Sensor
Elements
NOTE: Looking down inside the swivel you
wiil see a ring. The sensor elements are
located just slightly below this ring.
3. Reinstall the wand after cleaning the sen
sors.
22