Cleaning exterior and attachments, Motor safety filter changing, Warning – Kenmore ASPIRADORA 116.29914 User Manual
Page 17: Motor safety filter electrostatic, Motor safety fitter changing, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLEANING EXTERIOR AND ATTACHMENTS
1. Turn off and unplug vacuum cleaner, DO
NOT drip water on vacuum cleaner.
2. To ciearr exterior, or to reduce static elec
tricity and dust build-up, wipe outer surface
of vacuum cleaner and attachments, Use a
clean, soft doth that has been dipped in a
solution of mild liquid detergent and water,
then wrung dry. Wipe dry after cleaning
CAUTION
Do not use attachments if they are wet
Attachments used in dirty areas, such
as under a refrigerator, should not be
used on other surfaces until they are
washed. They could leave marks.
MOTOR SAFETY FILTER CHANGING
WARNING
Electrical Shock Hazard
Turn off and unplug vacuum cleaner
from electrical outlet. Do not operate
the vacuum cleaner without the motor
safety filter. Be sure the filter is dry and
properly installed to prevent motor
failure and/or electrical shock.
MOTOR SAFETY FILTER
ELECTROSTATIC
This filler must be replaced when dirty It
should be replaced regularly depending on
use conditions. The Rlter CANNOT be
washed as it will lose its dust trapping
ability.
NOTE: See PARTS AND FEATURES for
Motor Safety Filter number,
1. Remove the bag as outlined in the BAG
CHANGING section
2. Lift the rubber
retainer and puli out
motor safety filter as
shown
Rubber
Retainer
3. Replace the filter,
white side facing
toward dust bag, by
sliding it back into
place under the ribs in
the bag cavity Tuck
filter in so that it fils
completely under the
rubber retainer.
4. Replace the bag as outlined in the BAG
CHANGING seclion
17