Kenmore 88329 - Manual (Page 21)

PROGRAMMED DEFROST
The power levels for defrosting are predetermined and programmed into this oven. The oven will defrost at “HI” power
for the beginning of the chosen time and at power level 30 for the remaining period of time.
1. Touch CLEAR.
2. Touch PROGRAMMED DEFROST. “0” will show in
the display window.
3. Set the defrosting time by following the “Programmed
Defrosting Chart” on Pages 22 through 25.
4. Touch START. The oven will begin and the time will
begin counting down in the display window. A tone
will sound when the time is over and the oven will
automatically shut'off.
NOTE: If you plan to use additional cooking stages
immediately following Programmed Defrost cycles, you
must allow for standing time as recommended on the
Programmed Defrosting Charts on pages 22 through 25.
This can be accomplished as follows:
1. Touch PROGRAMMED DEFROST and enter the
defrosting time.
2. Touch MEMORY/RECALL.
3. Touch TIME.
4. Enter standing time per charts
(pages 22 thru 25).
5. Touch POWER CONTROL.
6. Enter “0”.
7. Touch MEMORY/RECALL.
8. Set the next cooking stage per cookbook or USE
AND CARE INSTRUCTIONS.
The cooking process can be set for up to 3 stages when
Programmed Defrost is one of the stages.
EXAMPLE: To defrost two pounds of ground beef, use
the PROGRAMMED DEFROST cycle for 9 minutes.
1. Touch CLEAR.
2. Touch PROGRAMMED
DEFROST. The display
window will show “0”.
3. Set 9 minutes by touching “9”,
“0” and "0”. “900” will show in
the display window.
I ga IHH
mmm
FTimm
ii I
DOOnnaEAEE
Ksnmore
mrrim
caciDm
mrenrFi
OOOR ?!E l E* 3 £
o
4. Touch START. The oven will
begin to operate and time will
begin to count down in the dis­
play window,
A tone will sound and the word
“End” will show in the display
window for two seconds when
time is over and the oven will
automatically shut off.
mrTim
QDmm
mmm
aej.F.i5E
Cm)
21