GE VG4275 - Manual (Page 22)

SETTING UP THE VCR
The Set Auto Repeat dialog box will ask for a loop end
time to be specified:
A U T O R E P E A T
S e t t h e l e n g t h o f t i m e
y o u w a n t t h e t a p e t o
p l a y i n a r e p e a t i n g l o o p
L o o p f r o m 0 : 0 0 t o - :
_
C h : m m )
P r e s s M E N U t o e x i t
• The CLEAR key will erase all three numbers entered
and move the cursor back to the first position (hours).
• The "Press CLEAR to turn off" message will appear
only after the first number has been entered into the
end time.
• Auto Repeat is set back to by resetting the dialog
box, by cassette ejecting or insertion, by powering off
the VCR, by power interruption, or by recording start.
When a duration time has been set:
• The VCR will automatically switch to rewind if the
counter meets or goes past the Auto Repeat set
duration.
• The VCR will automatically switch to playback during
rewind if the counter equals or is less than 0:00.
• The Auto Repeat may be adjusted by setting the
counter to 00:00. This can be done by pressing the
CLEAR button while the tape counter is on screen or on
the front panel display.
• The counter will not reset while rewinding in an Auto
Repeat loop. Front Panel Brightness (VCR Display)
You can change the brightness level of the fluorescent
display panel on the front of the VCR. Press 5 to switch
between the options.
• AUTO brightens the display when the VCR is on and
dims the display when the VCR is off.
• BRIGHT keeps the display bright.
• DIM keeps the display at a low brightness level.
20