Setting up the vcr, Changing the signal type, Adding or removing channels – GE VG4275 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETTING UP THE VCR

Detect Automatically makes

this determination without

assistance.

A U T O C H A N N E L S E A R C H

N o w s c a n n i n g c h a n n e l 1 4

P r e s s a n y k e y t o c a n c e l

The VCR scans for available channels which takes about

one-to-two minutes. When the scan is complete, the VCR

tunes to the lowest channel number available. At this

point, pressing CHAN up or down on the VCR or remote

control should only select the active channels.

Changing the Signal Type

1. Press MENU to display the VCR MAIN MENU.

2. Press 4 to display the CHANNELS menu.

3. Press 3 to change the Signal Type between CABLE and

ANTENNA.

Adding or Removing Channels

You may want to add or remove channels after you Auto

Channel Search, especially if some of the channels have

weak signals or you don't want to watch them.

1. Press MENU to display the VCR MAIN MENU.

2. Press 4 to display the CHANNELS menu.

3. Press 2 to display the ADD/REMOVE CHANNELS

screen. Use CHAN up or down or number buttons to

go to the channels to be removed or added.

A D D / R E M O V E C H A N N E L S

C h a n n e l 1 1 5

C h a n n e 1 1 1 5

i s p r e s e n t l y A D D E D

i s p r e s e n t l y R E M O V E D

P r e s s C L E A R t o r e m o v e

P r e s s I N F O t o a d d

P r e s s M E N U t o e x i t

Auto Channel Search

Use the Auto Channel Search

feature to place all available
channels in memory.

If you ever change cable or antenna
signals, you may need to Auto

Channel Search again.

Detect Automatically

A strong cable or antenna signal in
your area may cause Auto Detect to
mis-detect. If this should happen,
select 1 or 2 for the system you
have.

4. Follow the on-screen instructions to finish this set up.