Cabletron Systems EMM-E6 - Manual (Page 52)

Alarm Configuration
3-2 Using Alarm Configuration
Using Alarm Configuration
To open the Alarms window
from the icon:
1. Click on the appropriate EMM-E6 icon to display the icon menu.
2. Drag down to Alarm Configuration and release.
from the Hub View:
1. In the Hub View, click on to display the Device menu.
2. Drag down to Alarm Configuration and release to open the Repeater Alarms
window.
from the command line (stand-alone mode):
1. From the appropriate directory type:
spmarun r4al
Figure 3-1. Repeater Alarms Window
NOTES
The spmarun script invoked first in the above command temporarily sets the environment
variables SPMA needs to operate; be sure to use this command any time you launch an
application from the command line. The script is automatically invoked when you launch
the application from the icon menu or from within the Hub View.
If you wish to change any Alarm Configurations, be sure to use a community name with
at least Read/Write access. If you only wish to view current settings, a community name
with Read access will be sufficient.
If there is a hostname mapped to your EMM-E6’s IP address, you can use
in place of to launch this application. Please note, however, that the
hostname is not the same as the device name which can be assigned via Local
Management and/or SPMA; you cannot use the device name in place of the IP address.