Cabletron Systems EMM-E6 - Manual (Page 11)

Using the EMM-E6 User’s Guide 1-3
Introduction
• Chapter 8, Front Panel Redundancy , describes how to configure redundancy
for the two Channel D EPIM ports on the EMM-E6’s front panel. You can
access the Front Panel Redundancy application from the icon menu, the Hub
View, or the command line.
• Appendix A, EMM-E6 MIB Components , lists the IETF MIBs supported by
the EMM-E6, and describes their arrangement in a series of MIB components.
A description of the objects controlled by each component is also included.
What’s NOT in the EMM-E6 User’s Guide. . .
The following standard SPMA tools are available through the EMM-E6 module
and are explained in the
SPECTRUM Portable Management Application Tools
Guide :
• Bridge View
• Charts, Graphs, and Meters
• Community Names
• Distributed LAN Monitor (DLM)
• MIB I, II
• MIBTree
• Path
• Telnet
• TFTP Download
• Trap Table
• UPS
• Utilities (Global Community Names, Find MAC Address and TFTP)
Charts, Graphs, and Meters are accessible from the Hub View and the command
line; the Utilities, MIBTree, and RMON Configuration applications are accessible
from the platform console window Tools menu, the Stand-alone Launcher
applications menu, or the command line; and the rest of the tool applications
(except Telnet) are available from the icon menu, the Hub View, or the command
line. (The Telnet application is available only from the icon menu or the command
line.)
An additional application may also appear on the platform console window Tools
menu or the Stand-alone Launcher applications menu:
• RMON Configuration
Note that this application must be purchased separately, and is documented in its
own
User’s Guide .